Category Archives: cryogenic

The 5 T’s of Cryogenic Deburring Machined Parts

The Cryogenic Deburring Process Cryogenic Deburring is a process designed to remove machining burrs created during the machining process. Machining burrs can be found on CNC machined parts along surfaces that are manufactured from material stock. In order for machined parts to complete their desired function, the residual machining burrs need to be removed. Nitrofreeze® […]

Continue Reading...

The Five T’s of Cryogenic Deflashing Molded Parts

The Cryogenic Deflashing Process Cryogenic Deflashing is a process designed to remove molding flash created during the molding process. Molding flash can be found on molded parts along the parting lines, gate vestiges, and where pins and slides are located. In order for molded parts to complete their desired function, the residual molding flash needs […]

Continue Reading...

Remove Mold Flashing

Remove Mold Flashing From Injection Molded Parts

Batch Deflashing to Remove Mold Flashing We often hear from molders and OEMs that they have mold flashing after their injection molded plastic and rubber parts are manufactured. There are many ways for mold flashing to form on your parts during the injection molding process. Surfaces where sliding and moving parts meet will wear with […]

Continue Reading...

cryogenic deflashing

Sick & Tired of Paying for Issues from Hand Trimming?

Are you sick and tired of paying for quality issues caused by hand deflashing? We hear it all the time. You have a section in your manufacturing operation with a team of deflashing personnel sitting around a table. Your team may have seasoned veterans, but you still end up with a varying degree of flash […]

Continue Reading...

cryogenic shrink fitting

Cryogenic Shrink Fitting for Tight Tolerance Parts

Shrink fitting uses temperature to change the dimensions of parts so that components fit and hold together. This joining technique is used in sub-assemblies to create a tight, interference fit between inner and outer components so that relative motion won’t occur or force can be transmitted from one part to another. Common shrink fitting applications […]

Continue Reading...