Tag Archives: cryogenic treatment

Cryogenic Treatment for Drill Bits

Every Friday we start our processor and complete a weekend run. We load the parts in and then set our process parameters for the run. We use ramps that go down no more than a degree per minute and we hold all the parts at -300°F for a total of 24 hours. Upon completion of […]

Continue Reading...

Improve the Wear Resistance of Motorsports Parts

In the racing industry, it is not unusual to see a high level of wear in parts that are subject to friction. As the parts rub against each other over time a thin layer of material can be removed. This will result in less efficiency and in some cases lower horsepower and torque figures. A […]

Continue Reading...