Nitrofreeze® cryogenic deflashing removes flash from glass-filled PEEK coupling rings. This fast, efficient and consistent finishing process uses gaseous nitrogen to freeze the parts and plastic media to break-off surface imperfections and excess material. Because it’s a batch process, cryogenic deflashing eliminates manual deflashing such as hand trimming for faster throughputs and reduced labor costs. […]
Nitrofreeze® cryogenic deflashing removes flash from silicone bumper stops. This fast, consistent and cost-effective process uses gaseous nitrogen to freeze the parts and plastic media to break-off surface imperfections and excess material. Thanks to batch processing, cryogenic deflashing can also reduce lead times and labor costs. The Challenge Nitrofreeze was asked to remove flashing from […]
Nitrofreeze® Cryogenic Deflashing provides part molders and OEMs with a fast, consistent way to remove flash from rubber components including natural rubber, silicones, EPDM, Polyurethane, Neoprene, Viton, Vamac,butylrubber, and more . Cryogenic deflashing uses gaseous nitrogen to freeze the parts, and plastic media to break-off the surface imperfections and excess material. This safe, clean process […]
Nitrofreeze® cryogenic deflashing provides part molders and OEMs with a fast, consistent way to remove flash from silicone distal handles. Cryogenic deflashing uses gaseous nitrogen to freeze the parts, and plastic media to break-off the surface imperfections and excess material. This safe, clean process is also cost-effective because it supports batch processing. The report below […]
Overview Cryogenic deburring and deflashing systems are versatile by design to meet the wide ranging demands of machined and molded parts. As parts vary in physical properties and geometry, a unique set of processing parameters is required for each part. All new parts submitted for Nitrofreeze Deburring or Deflashing undergo a process development phase known as […]
